Cross Bar with 2 Snap Clips — Rail-Mount Bar for Modular Kits (Parametric, 3D Print)

🔖 Art. ML3D_0054

Cross bar with two snap clips by MarineLab3D — a flat bar with a C-clip at each end (from the Custom Wall Clip Holder ML3D_0027, wall plate removed), so you can snap it onto two parallel tubes, rails or guardrails with no drilling and no bolts. Each clip is fused into a saddle seat with a 4.1 mm stand-off, and snaps over the tube with a flared lead-in. Set the clip bore and the bar length (centre-to-centre of the two clips) and receive your STL file. 🔧 Two C-clips, perpendicular to the bar, on the wide face — snap onto rails/tubes, no holes in the structure. 📏 Fully adjustable: clip inner Ø and bar length (centre-to-centre). 🧱 Saddle seat + 4.1 mm stand-off = solid, precise clip-to-bar joint. 🔩 No hardware: snap-fit, the flared knobs guide the tube in and hold it. 🔄 Move your modules where you need them. Want to relocate a holder for a passage — e.g. take the cabin VHF module outside while under way, or move the Garmin/chartplotter to the helm? Snap this bar onto a rail or guardrail and hook your module on, no tools on the structure, no drilling. Take it off when you're done. 📐 Bar length = centre of one clip to centre of the other (i.e. the spacing between the two tubes/rails you snap onto). 🧩 Optional rail-mount bar for these MarineLab3D modular kits — use it instead of the screw-on wall rail to hang the kits on tubes/guardrails: Modular Jar Kit — Wall Rail + 1–3 Square Jars (ML3D_0041) Modular Rail Device Holder Kit — 1–3 Holders (ML3D_0042) Modular Cylinder Holder Kit — Can · Bottle · Pens · Cup (ML3D_0052) 🧵 Print: PETG or ASA, 0.2 mm layers, 3+ perimeters. Prints flat, no supports. Single STL file — no assembly. Use "Customize" to set the clip Ø and the bar length

Related designs: Twin Pipe-Clamp Cross Bar — Rail-Mount Bar for Modular Kits (Parametric, 3D Print), Modular Cylinder Holder Kit — Can · Bottle · Pens · Cup + Wall Bar (Parametric, 3D Print), Modular Wall Hook Rail — Up to 5 Hooks on a 2-Screw Bar (Parametric, 3D Print)

Disclaimer. MarineLab3D sells digital 3D files, not finished parts. The strength, fit and safety of the printed part depend on your printer, material, settings and assembly, which are outside our control. Verify all dimensions before printing, use the recommended material and inspect every print. Provided “as is” without warranty; to the maximum extent permitted by law MarineLab3D is not liable for any damage, loss or injury arising from their use. Not certified marine equipment. Full Disclaimer & Terms of Use.